question

pcoronado avatar image
0 Likes"
pcoronado asked

Fortianalyzer Throughput Utilization Billing Report

I am trying to create a report that will tell me how much WAN usage my fortigates have at remote sites, in Fortianalyzer there is Throughput billing report that is supposed to let me select the interface on the remote fortigate I am running the report against, however, the section where you do that says "interface selection not supported", I have enabled via CLI with no success by doing:

config system log interface-stats

set billing-report enable

end


FortiAnalyzer
10 |600

Up to 8 attachments (including images) can be used with a maximum of 1.0 MiB each and 10.0 MiB total.

0 Answers

·

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MiB each and 10.0 MiB total.

Welcome to FortiAnswers

FortiAnswers is the space dedicated to FortiSASE and FortiOS questions and suggestions.

  • Please review the Community guidelines
  • If you are a moderator, please refer to the Moderation guidelines
  • If something in the above guidelines is unclear, please post your question to the Community Feedback space or the Moderators' space