I am trying to configure our core Cisco 9300 to pass vlan traffic to
Standalone Fortiswitch FS-224E. I have a ticket opened with both Cisco
and Fortinet and have had both engineers on the phone but we were not
able to get it to work. Does anyone have...
config-version=S224EN-7.02-FW-build444-230317 yea each time i reboot, i
have a second 224 swtich and it also does the same thing when you reboot
after configuring.
Update: The settings are saving the issue is with the internal port, it
is set to thisconfig switch interfaceedit internalset native-vlan 100
Somehow it is losing that config, when I console back in and add that to
port 1 I gain access to gui and pin...
Ok, so new issue, when I put the switch in the building where it's going
to go, what's going on now is that when I power cycle the switch I lose
access to it I can only connect using cli. Any idea?
Thanks you have been beyond helpful, this is now working for me. If i
want to copy all of the current configuration to a notepad for future
reference what command can I run from cli? I know on cisco i do
something similar using show run command.
Awesome, that worked I can ping the switch now with the ports trunked.
And for assigning Vlans to ports native Vlan should stay at 1 and
allowed vlans should be either 100 or 200 depending on which one I want
them on?